{
  "title": "Photographic equipment wholesale kit and interface data for AI",
  "source_page": "https://fiund.com/industries/photo-equipment-wholesale-kit-interface-data",
  "authorship": "Original fictional Fiund editorial exercise. No actual operating records or third-party source assets are included.",
  "example": {
    "title": "A plug shape can match while cable capability and kit membership disagree",
    "context": "Two original inert camera-accessory props use abstract interface and performance codes. There is no real cable claim, firmware, serial, vendor image or buyer information.",
    "records": [
      [
        "PKI1",
        "Dummy kit manifest",
        "Kit K expects accessory A with connector shape C and documented capability Q1. Original revision M2 explicitly names A."
      ],
      [
        "PKI2",
        "Prop photo",
        "Observed accessory B shows connector shape C and readable B code. No capability marking visible."
      ],
      [
        "PKI3",
        "Independent specification",
        "Matched B card states capability Q2, not Q1. Folder's swapped manifest line says B but is unapproved and does not replace M2."
      ]
    ],
    "question": "What can be identified visually, what capability is documented, and does B satisfy K's current manifest?",
    "answer": "PKI2 supports B identity and connector shape C, but cannot reveal a capability from shape. PKI3 independently documents Q2 for B. PKI1 still requires A and Q1, so shared connector geometry and an unapproved swapped line do not establish kit membership. Preserve visible interface, documented capability and approved component scope separately rather than infer complete compatibility or an actual cable performance guarantee.",
    "failureModes": [
      "Inferring capability solely from connector shape.",
      "Treating an unapproved manifest entry as authority to replace a kit component."
    ],
    "fields": [
      [
        "Kit, accessory and manifest revision",
        "Defines membership."
      ],
      [
        "Visible connector and identity code",
        "Supports observation."
      ],
      [
        "Capability source and approval state",
        "Limits the match."
      ]
    ],
    "holdout": "Add an approved B substitute for one kit revision but retain a Q1 requirement. Require the remaining capability conflict to stay visible.",
    "boundary": "Use original owned props and artwork. Exclude vendor imagery, serials and firmware; clear performer and location rights for footage."
  }
}